Advertising in MoldMaking Technology offers
Issue link: https://mmt.epubxp.com/i/485569
TIP 64 MoldMaking Technology April 2015 Reduce Part Failure with Melt Delivery Science HOT RUNNERS FOR MORE INFORMATION: Incoe Corp. / 248-616-0220 jim.bott@incoe.com / incoe.com CONTRIBUTOR Jim Bott is new business development manager for Incoe Corp. Image courtesy of Incoe Corp. Here is an example of an FEA thermal analysis of a bridge and main manifold. By Jim Bott The best way to determine when naturally balanced, rheologi- cal managed and thermally balanced hot runner solutions are required as a single solution is to examine the science behind each approach. Naturally balanced hot runner systems are used in multi-cav- ity mold applications where all the parts are the same. They are designed with equidistant flow paths and flow diameters held to tolerance. These applications allow for the use of manifolds with multi-level flow paths to achieve equal flow lengths to each of the cavities or the use of a bridge manifold. Rheological managed hot runner systems are based on the flow of matter from which the Hagen–Poiseuille equation was developed. Still used today to calculate deltas in pressure drop for non-Newtonian fluids such as plastic, this equation has been recognized as essen- tial to achieving true cavity- fill management by mapping dynamic viscosity variations as the plastic flows from the machine barrel into a hot run- ner system and then into the part. Mapping the distribution of the relative high and low plastic laminates and then managing those laminates so they are homogenously delivered to the cavity is crucial to the success of some applications. Thermally balanced hot runner systems are designed to be thermally stable and homogenous throughout the manifolds and nozzles. This stability is easy to achieve when a system is sitting on a test bench, thermally isolated from surface contact that will influence heat distribution, but it is not so easy when the system is within a mold and in contact with various surfaces and cooling elements. Finite element analysis (FEA) and the right temperature controllers can be used to help meet this goal. To illustrate the successful use of these three applied sci- ences as an all-in-one solution, let's look at a specific 32-cavity, direct-valve-gated, preform mold application. The mold build- er could not understand why the medical preform OEM/mold- er took "perfectly fine" molds and retrofitted the existing hot runner systems. To the mold builder's knowledge, the molds performed well, but short-shot analysis proved otherwise. In addition, the delta in part fill directly corresponded to the frac- turing failure of the bottles in the blow molding process. The failure rate the molder was experiencing was considered "acceptable" until a deeper study of the fill patterns in relation to the fracture during the blow molding process proved that there was a direct correlation between bottle failure and pre- form filling patterns. The existing molds used hot runner systems with naturally balanced and thermally balanced manifolds, but application of melt management science was missing. After the molder was introduced to rheological imbalances and the scientific approach to melt management, an investment in a mold using all three runner system approaches was made, and the results were favorable. This change yielded a substantial decrease in part-to-part weight variance and improved fill pattern in all stages of progressive short-shots. This, in turn, led to a reduc- tion in part failure during the blow molding process, a six-fig- ure material savings in the first year, faster mold startups and a more open process window. Changing to an all-in-one approach to melt delivery led to a reduction in part failure during the blow molding process, a six- fgure material savings in the frst year, faster mold startups and a more open process window.