MoldMaking Technology

SEP 2018

Advertising in MoldMaking Technology offers

Issue link: https://mmt.epubxp.com/i/1016849

Contents of this Issue

Navigation

Page 65 of 67

TIP 64 MoldMaking Technology —— SEPTEMBER 2018 Carbide and Coating Considerations CUTTING TOOLS By Mike MacArthur Choosing the correct car- bide grade, cutter geometry and cutting-tool coating amid the wide variety of moldmaking materials and available cutting-tool options can be a challeng- ing task for mold builders today. However, keeping an open dialog with your cutting-tool manufacturer will help save time and money. Plus, there are exciting developments with new carbide grades, geometries and coatings that can help solve many mold-machining pain points. Here are two examples to consider when machining aluminum and hardened-material molds. Mirror-edge geometry. Depending on the material you are cutting, the best tool for your application can reduce the cost of machining your mold by more than 500 percent. Take, for example, a mirror-edge geometry that eliminates chatter in aluminum molds. Typically, when carbide tools stick out of the spindle by more than a 3:1 length-to-diameter ratio, chatter becomes an issue, and exceeding the 3:1 ratio is the norm in mold machining. Many machine operators choose to slow things down or are forced to take very shallow depths per pass to remedy the chatter problem. However, the mirror-edge geometry synchronizes the vibration of the end mill with the vibration of the mold. This synchronized movement eliminates the chatter, improving the finish. The other advantage that it offers is the ability to increase rpms to the maximum range of the machine, which greatly improves removal rates. This technology can remove as much as 42 pounds of alu- minum every minute. One mold builder using a mirror-edge geometry took deeper cuts with faster feed rates without chatter. As a result, the mold builder reduced a 49-minute roughing cycle time using three different tool lengths to eight minutes using only one long-length tool. The shop reduced cycle time by 525 percent. Wear-resistant carbide and heat-resistant PVD coatings. When cutting difficult, hardened materials such as D2 at 62 HRC, getting a ball end mill to last long enough to get through the entire part can be difficult. The desire for mold-component interchangeability and ever-tightening tolerances make it extremely challenging when you are forced to change tools midway through a part. One solution is a newly developed carbide-grade combination with a heat-resistant coating. When cutting hardened materials, wear is typically the failure mode. A harder carbide grade with the same mechanical toughness will wear less than a softer carbide grade. Another mode of failure when cutting hardened parts is the high temperatures at the cut. A new specialized PVD coating acts as a heat shield during cutting, which extends cutting-tool life. Using a carbide-grade combination with a heat-resistant coating and a specialized PVD coating can extend cutting-tool life by 450 percent and reduce wear on the ball by 909 percent. This increases 3D accuracy and allows the entire part to be completed with one tool, eliminating the potential of mismatch from the use of multiple tools. CONTRIBUTOR Mike MacArthur is vice president of engineering for RobbJack Corp. Mirror-edge geometry can remove as much as 42 pounds of aluminum every minute. Images courtesy of RobbJack Corp. The image on the left shows the surface of a cutting tool with a hard metal carbide grade and coating that is typically used for mold machining. The image on the right shows the cutting tool surface with a new carbide grade and coating combination designed to last longer. FOR MORE INFORMATION RobbJack Corp. / 844-342-0238 / robbjack.com

Articles in this issue

Links on this page

Archives of this issue

view archives of MoldMaking Technology - SEP 2018