MoldMaking Technology

AUG 2018

Advertising in MoldMaking Technology offers

Issue link:

Contents of this Issue


Page 81 of 83

TIP 80 MoldMaking Technology —— AUGUST 2018 Advancing Anode Assembly Fabrication SURFACE TREATMENT By Luis Gonzalez Fabricating a conforming anode assembly is a necessary step when chrome plating injection and compression molds, but not all plating operations approach this step in the same way. While a conforming anode is only one element in the elec- troplating process, the quality of the assembly strongly impacts certain critical parameters, such as plating film thickness, uniformity over geometrically complex molding surfaces and pitting control. Anode materials have evolved, but the current standard for functional plating of molding surfaces is still a system of individual, steel-wire anodes. Platers used to fabricate anodes with malleable, perforated lead sheets. These sheets worked to a point, but some people believed they had a potentially unsafe impact on the working environment. An ISO14001-registered operation has incentives to seek alternative options, like custom-building the anode assemblies on a base frame of square, aluminum bars with mild, steel-bent wires that are individually attached to the frame and conformed to the tool's specific geometry, for example. Aluminum as a choice for the frame yields a more-even current dis- tribution throughout the assembly, which has a significant impact on minimizing pitting in the plated surface. Minimal pitting is a primary per- formance requirement for many customers' projects, especially for in-mold finishing tools. The number of wires that are required depends on what it takes to con- form to the geometry, which can be 300 or more for a large, complex tool, like a fiberglass bathtub or for an automotive body panel. This network of individual wires makes it possible for the overall assembly to become an inverse duplicate of the forms to be plated, which is critical for maintaining a consistent plating thickness within a narrow tolerance range over very geometric, complex surfaces. As with every mature process, there is always room to evolve. The anode component of the plating process is no exception. For example, many chrome-plated tools, especially those for high-percentage, glass-filled parts, have grooves for stiffening ribs in the molded component. These grooves can experi- ence release failure well before the rest of the mold. Reliably chrome plating the grooves to the same tolerances as the rest of mold will increase the lifecycle and maintenance intervals, and improved release and resin flow will decrease cycle time. One solution for accomplishing these benefits is a system of individual blade anodes that rests within the grooves. This common method has been refined to enable the blades to remain centered within the grooves while submerged in the plating bath. This is a critical step for preventing the blades from contacting the mold and causing burning of the groove faces, which leads to unplated areas or inconsistent film thick- ness within the grooves. Another refinement addresses the current differential between the wire and blade anodes, ensur- ing uniform plating thickness with both anode types. Molds with grooves for stiffening ribs that use these meth- ods can yield groove-wear patterns consistent with the wear on the rest of the mold, which improves molding performance, tool life cycle and maintenance intervals. CONTRIBUTOR Luis Gonzalez is president of Surfacetec. Images courtesy of Surfacetec. Precise placement and fixity of the bladed anodes ensure that they remain centered within the grooves during the plating operation, avoiding burning of the groove surfaces by contact, which leads to areas of inconsistent plating film thickness. FOR MORE INFORMATION Surfacetec / 630-521-0001 / Deep grooves for stiffening ribs are seen in many tools and can potentially encounter release failures well before the rest of the mold unless they are plated to the same tolerances required of the entire tool.

Articles in this issue

Links on this page

Archives of this issue

view archives of MoldMaking Technology - AUG 2018